Individual Account Settings - Grandstream Networks GXP – 2000 User Manual

I A S
NDIVIDUAL CCOUN T ETTINGS
The GXP–2000 ha s 4 line appearances, each with an independent SIP account. Each SIP account
requires its own c nfiguration page. Their configurations are identical. o
Table 12: SIP A cc ount Configuration Page Definitions
Account Active
Account Name
SIP Server
Outbound Proxy
SIP User ID
Authenticate ID
Authenticate Password
Name
Use DNS SRV:
User ID is Phone
Number
SIP Registration
Un–register on Reboot
Register Expirati on
Local SIP Port
Grandstream Networks, Inc.
This field indicates whether the account is active. The default value for the
primary account (Account 1) is Yes. The default value for the other two accounts
is No.
The name associated with each account –displayed on LCD.
SIP Server's IP address or Domain name provided by VoIP service provider.
IP address or Domain name of Outbound Proxy, Media Gateway, or Session
Border Controller. Used for firewall or N
environment. If the system detects symmetric NAT, STUN will not work. ONLY
outbound proxy can provide solution for symmetric NAT.
User account information provided by VoIP service provider (ITSP); either an
actual phone number or formatted like one.
SIP service subscriber's Authenticate ID used for authentication. It can be
identical to or different from SIP User ID.
SIP service subscriber's account password for GXP–2000 to register to (SIP)
servers of ITSP.
SIP service subscriber's name that is used for Caller ID display.
Default is No. If set to "Yes", the client will use DNS SRV to look up server.
If the phone has an assigned PSTN telephone number, this field should be set to
"Yes". Otherwise, set it to "No". If "Yes" is set, a "user=phone" parameter will be
attached to the "From" header in SIP request
This parameter controls sending REGISTER messages to the proxy server. The
default setting is "Yes".
Default is No. If set to "Yes", the SIP user's registration information will be
cleared on reboot.
This parameter allows user to specify the time frequency (in minutes) that GXP–
2000 refreshes its registration with the specified registrar. The default interval is
60 minutes. The maximum interval is 65,535 minute
This parameter defines the local SIP port used to listen and transmit. The default
valu e for Account 1 is 5060. It is 5062, 5064, 5066 for Account 2, Account 3 and
Account 4 respectively.
GXP–2000 Users Manual
Firmware 1.1.1.14
AT penetration in different network
s (about 45 days).
Last Updated: 04/2007
Page 23 of 33