Pentax *istD Operating Manual page 151

e_000_kb321.book Page 150 Wednesday, August 27, 2003 12:09 PM
150
• Do not use a spray type blower.
• Do not clean the CCD when the exposure mode is set to p (Bulb) mode.
• Always cap the lens mount area to prevent dirt and dust from accumulating
on the CCD when no lens is on the camera.
• It is recommended that you use the AC adaptor when cleaning the CCD.
• When the battery level is low, "Not enough battery remaining to clean sensor"
is displayed on the LCD monitor.
• If you are not using the AC adapter, please use batteries with ample capacity
remaining. A warning beep will sound if the battery capacity becomes low
during cleaning. Please interrupt your cleaning operation immediately.
• Do not put the tip of the blower inside the lens mount area. If the power is
turned off, this could cause damage to the shutter or the CCD sensor.
8