Pentax PocketJet User Manual page 13

Setting Up the Printer
CAUTION: Do not force the battery connector into the
terminal. If you are having difficulty inserting the con-
nector, make sure the connector tab is facing the top
of the printer case. See Figure 3.
Grasp the battery removal ribbon, which is attached
to the inside of the battery compartment. See Figure 4.
NOTE: If you forget to hold on to the ribbon, you may
accidentally insert the battery on top of it. Then you
won't be able to remove the battery by pulling on
the ribbon.
FIGURE 4. Placing the battery inside the
battery compartment.
While holding on to the ribbon, tilt the battery and
place it inside the battery compartment. Once the
battery clears the outer edges of the compartment,
press it securely into position.
Make sure the side of the battery with the warning label
faces the outside of the battery compartment.
Otherwise, the battery cover will not close properly.
NOTE: The side of the battery opposite the warning
label contains a heat sensor that stops the flow of elec-
tricity if the battery overheats.
Attach the battery cover to the end of the battery
compartment opposite the AC adapter receptacle.
Close and latch the cover. If necessary, gently push the
cover latch toward the AC adapter receptacle until it
latches.
Removal Ribbon
7