Defrosting The Fridge; To Change The Light Bulb; When The Appliance Is Not In Use - Electrolux ERF3700 Instruction Book

External Cleaning
Use water/neutral soap emulsion for cleaning the
surface of stainless steel, anti-finger-print coated.
Absolutely not to use abrasive paste.
Wash the outer cabinet with warm soapy water.
Remove the ventilation grille (see the section
"Removing the ventilation grille") and vacuum-clean
under the cabinet. Once or twice a year dust the
condenser (black grille) and the compressor at the
back of the appliance, with a brush or vacuum
cleaner, as an accumulation of dust will affect the
performance of the appliance and cause excessive
electricity consumption.
Defrosting the freezer
Defrosting is not necessary.
Every 24 hours, the evaporator is defrosted
automatically.

Defrosting the fridge

The fridge is defrosted automatically every time the
compressor stops. Frost formation can be prevented
by:
· not putting warm foodstuff inside the cabinet.
· avoiding frequently opening the door or keeping
it open too long.
· do not place foodstuffs directly against the cold
cooling plate.

To change the light bulb

The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
Cut the packaging around the bulb socket.
Keep the packaging on to hold the bulb when setting
it into the socket. Do not touch the bulb with your
bare fingers. Halogen light bulbs are sensitive to
grease from the skin.
Use a clear halogen light bulb.

When the appliance is not in use

Disconnect the appliance from electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food inside
from spoiling in case of a power failure.
When moving the cabinet, lift it by
the front edge to avoid scratching the
floor.
G4
20W/12V
11
UV-blocked
Low pressure
Electrolux 818 39 45-00/8