Configuring Pppoe Unnumbered For Wan - Asus RX3042H User Manual

RX3042H User's Manual
Setting
MTU
Disconnect
after Idle
(min.)
Connect on
Demand
Status
Manual
Disconnect/
Connect
5.2.3.2 Configuring PPPoE Unnumbered for WAN
Follow the instructions below to configure PPPoE unnumbered
settings:
1. Open the Network Setup configuration page by clicking the
Router Setup -> Connection menu.
2. Select which WAN port (WAN1/WAN2) to configure for PPPoE
unnumbered connection mode.
3. Select PPPoE Unnumbered from the WAN Connection Mode
drop-down list as shown in Figure 5.4.
4. Check NAPT box if NAT is to be used for this connection.
5. Enter user name and password provided by your ISP
6. (Optional) Enter the service name and/or AC name if required by
your ISP.
7. Enter the IP address, unnumbered network address, and
unnumbered netmask provided by your ISP.
8. (Optional) Enter the IP addresses for the primary and/or
Description
You may specify the maximum size of the
transmitted packet. For PPPoE, the range of MTU
is from 546 to 1492. The default value is 1492.
Enter the inactivity timeout period at which you
want to disconnect the Internet connection when
there is no traffic. A value of 0 means no activity
time out. Note that SNTP service may interfere
with this function if there are activities from the
service.
Click on the Enable or Disable radio button to
enable or disable this option.
On: PPPoE unnumbered connection is active.
Off: No PPPoE unnumbered connection is active.
Connecting: RX3042H is trying to connect to your
ISP using PPPoE unnumbered connection mode.
Click the Disconnect or Connect button to
disconnect or connect using the PPPoE
unnumbered connection mode.
Router Setup
35