Wan Pppoe Unnumbered Configuration Parameters; Table 5.3 Wan Pppoe Unnumbered Configuration Parameters - Asus RX3042H User Manual

Router Setup
5.2.3.1 WAN PPPoE Unnumbered Configuration Parameters
Table 5.3 describes the configuration parameters available for
PPPoE Unnumbered connection mode.
Table 5.3. WAN PPPoE Unnumbered Configuration Parameters
Setting
Link
Connection
Mode
Enable NAPT Check or uncheck this box to enable NAPT for
User Name
and Password
Service Name Enter the service name provided by your ISP. Service
AC Name
IP Address
Unnumbered
Network
Address
Primary /
Secondary
DNS Server
34
Description
Select a port to configure. Available options are
WAN1, WAN2 or DMZ.
Select PPPoE Unnumbered from the connection
mode drop-down list. Traditionally, each network
interface must have a unique IP address. However,
an unnumbered interface does not have to have a
unique IP address. This means that when this option
is selected, the WAN and the LAN use the same IP
address. Network resources are therefore conserved
because fewer network IP addresses are used and
routing table is smaller.
this connection.
Enter the username and password you use to log into
your ISP. (Note: this is different from the information
you used to log into Configuration Manager.)
name is optional but may be required by some ISPs.
Enter the access concentrator name provided by
your ISP. Access concentrator name is optional
but may be required by some ISPs.
Enter a static IP address here for the PPPoE
unnumbered connection. This IP address must be
provided by your service provider.
Enter the network address provided by your ISP.
IP address of the primary and/or secondary DNS
are optional as PPPoE will automatically detect
the DNS IP addresses configured at your ISP.
However, if there are other DNS servers you
would rather use, enter the IP addresses here.
RX3042H User's Manual