Table of Contents
Advertisement
RX3042H User's Manual
Figure 10.5. SNMP Configuration Page
2. Check the SNMP Enable box to enable the SNMP support;
otherwise, uncheck the box.
3. Enter the RO (read only) and R/W (read and write) community
names.
4. Enter the IP address of the SNMP management station that
receives trap messages from the RX3042H.
5. Click on Apply button to save the settings.
10.6
Log Setup
Log messages are stored in dynamic memory and will disappear
after system is rebooted. To keep a copy of the log messages, you
can setup a syslog server and have RX3042H send out the log
messages to the server.
10.6.1 Setting Up Remote Logging Using a Syslog Server
Figure 10.6. Syslog Server Configuration
System Management
95
Advertisement
Table of Contents
