Table of Contents
Advertisement
Your Response 123e is now ready
for use.
Using a 3mm bit, drill two holes in the
wall 103mm vertically apart. Insert the
wall plugs (if necessary) then screw
in the screws, leaving a small gap
between the screw heads and the wall.
8
Route the line cord and power cord
through the channels on the base of
your Response 123e.
To prevent the handset from falling
when the base is wall-mounted, you
need to slide out the handset clip,
rotate it 180° and re-insert it.
Fit the wall-mounting bracket to the
base of the phone.
Advertisement
Table of Contents
