Programming The Ten Device Buttons - Home Theater Master MX-500 User Manual

2. Programming the Ten Device Buttons

1. Go to the program setting mode by pressing both the MAIN
and ENTER buttons simultaneously for three seconds.
2. Press the LEARN button.
3. Press the PAGE button.
4. Press any of the ten device buttons you wish to program into
the MX-500™ and place your original remote control head to head
with the MX-500™ about 2 inches apart on a flat surface.
5. Press the button on your original remote control you wish to
program into the MX-500™. Once the MX-500™ has received the
signal, the MX-500™ will flash "Good" on the LCD screen,
indicating it learned the code correctly. If it flashes "Fail", repeat
from Step 4 until it learns successfully. (Please enter the code
signal within 20 seconds of programming).
6. Once you complete the programming and wish to exit the
leaning mode, press the MAIN button. Exit from SET UP mode
by pressing the MAIN button once again.
13