Auto Scan With Three Digit Number; Press The Device You Wish To Program - Home Theater Master MX-500 User Manual

Lcd screen preprogrammed and learning remote control

Hide thumbs Also See for MX-500:

Table of Contents

2. Auto Scan with Three Digit Number

You can also program your remote control by sending out series

of Power Off commands for different brands stored in the library by

using the following steps.

1. Manually turn on the component you plan to operate.

2. Go to program setting mode in the remote control by pressing

both the MAIN and ENTER buttons simultaneously for three

seconds.

3. Select the P-PRO button next to the LCD screen.

(E.g. To program TV, press the TV button).

5. Select the device from which the scanned code table will be

selected. (E.g. If it is the TV code table, press the TV device button).

6. Point the remote control toward the component and press

either the UP or DOWN button on the LCD. (It will send out the

series of Power Off codes when the button is kept pressed and the

code number that are being sent are shown on the LCD). If the

right code number is sent, the component will turn off right after

the code number is transmitted.

Table of Contents

Show Quick Links

Table of Contents