Garrett PD 6500i User Manual page 25

3.5.1 PROGRAM
PROG: <current program set>, will appear on LCD. If user is authorized to
change the program, the user may scroll the menu of programs using the + /
- touchpads to find the new program. Stop scrolling when program desired
appears on LCD. (Refer to Table 4.2 for a listing and description of
programs)
Press ACCESS for the next adjustment or OPERATE to resume normal
operation.
3.5.2 BASE SENSITIVITY
At higher sensitivity settings, smaller metal objects are detected. Conversely,
at lower sensitivity settings, only larger metal objects are detected. Keep in
mind that the sensitivity should be set high enough so that the smallest
forbidden object (depending on your security needs) can be detected.
BASE SENSE: <current base sensitivity setting>, will appear on LCD. If
user is authorized to change the base sensitivity, the user may scroll from
1-200 using the + / - touchpads. To determine proper sensitivity setting, follow
ALARM LEVEL setting instructions in section 3.5.18.
SPECIAL NOTE
A final decision on program and base sensitivity settings is the sole
responsibility of the end user and must be determined by keeping the intent of
the security application.
Press ACCESS for the next adjustment or OPERATE to resume normal
operation.
3.5.3 ADJUST VOLUME
VOLUME <current volume setting>, appears on LCD. The user may use the
+ / - touchpads to increase or decrease the alarm volume from 0 - 12.
Press ACCESS for the next adjustment or OPERATE to resume normal
operation.
3.5.4 PATRON COUNTER
A built-in and user resettable traffic counter records the number of patrons who
pass through the walk-through. This is a "view only" menu item. To reset the
counter to zero, refer to section 3.5.8.
COUNT <number of patrons who have passed through the detector>.
Press ACCESS for the next menu item or OPERATE to resume normal
operation.
©2003 GARRETT METAL DETECTORS
GARRETT PD 6500i
USER MANUAL
25
PN 1532010 REV A