Table of Contents
Advertisement
10/100/1000Mbps LAN Supported
On the strength of Gigabit LAN controller on board, this motherboard provides
10/100/1000Mbps Ethernet for office and home use. The Ethernet RJ45
connector is located on the top of USB connectors. The right hand side LED
indicates link mode; it lights in orange when linking to network. The left hand side
LED indicates the transfer mode and will light in green when data is transferring
at 100Mbps (never lights while at 10Mbps), but will light in orange when
transferring in Gigabit's mode. To enable or disable this function, you may simply
adjust it through BIOS. To enable LAN wakeup function, you have to set the
"Wake on PCI Card" enable in the BIOS "Power Management Setup" section.
Speed LED (Left)
Green 100Mbps
22
ACT LED (Right)
Orange
Advertisement
Table of Contents
