Fiber Test Settings - Fluke DTX-MFM2 User Manual

Fiber Test Settings

Table 2 describes the test settings that apply to fiber
cabling.
Setting
SETUP > Fiber Loss >
Select a fiber type that is appropriate for the type you will test. Selecting Custom lets you create a
fiber type. See the Technical Reference Handbook for details.
Fiber Type
SETUP > Fiber Loss > Select the appropriate test limit for the job. The tester compares the fiber test results to the
selected test limit to produce PASS or FAIL results. Selecting Custom lets you create a test limit. See
Test Limit
the Technical Reference Handbook for details.
SETUP > Fiber Loss > Use Smart Remote mode for testing dual-fiber cabling.
Remote End Setup
Use Loopback mode for testing reference test cords and cable spools.
Use Far End Source mode with an optical source for testing individual fibers.
To access the fiber test settings turn the rotary switch to
SETUP; then select Fiber Loss. Use
tabs.
Table 2. Fiber Test Settings
Description
Fiber Test Settings
BC
to see different
-continued-
15