Remote Control - Dimplex DF3003 Owner's Manual

Operation
three red indicators
!
NOTE: The heater on your
fireplace may emit a slight,
harmless odor when first used.
This odor is a normal condition
caused by the initial heating of
internal heater parts and will
not occur again.
Resetting the Temperature Cut-
off Switch
Should the heater overheat, an
automatic cut out will turn the
heater off and it will not come
back on without being reset. It
can be reset by switching the On/
Off Switch to Off and waiting five
minutes before switching the unit
back on.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call Dim-
plex North America Limited at
1-888-346-7539.

Remote Control

The fireplace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with one of
illuminate. 2,178 independent frequencies
to prevent interference with other
units. The frequency designation
is indicated on the back of the
transmitter.
!
NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out
from between the remote cas-
ing and battery cover (Figure
4).
Remote Control Usage
The remote control operates the
fireplace levels sequentially. The
level is increased every time the
ON button on the transmitter is
pressed.
The fireplace can be turned off
at any point by pressing the OFF
button on the remote control
transmitter.
Level 1 : The flame effect
is turned on and the first red
indicator light illuminates.
Level 2 : The flame effect
remains on, the heater is acti-
vated to the low heat setting,
and the first and second red
indicator lights illuminate.
Level 3 : The flame effect
11