JVC KD-AVX1 Instructions Manual page 47

Indications
Amp Gain
Amplifier gain control
AV INPUT
Audio-Video input
* 4 Reverse gear signal connection is needed to change the monitor view automatically. See
Installation/Connection Manual (separate volume).
Selectable settings, [reference page]
You can change the maximum volume level of this receiver.
High Power: [Initial]; VOL 00 – VOL 50
Low Power: VOL 00 – VOL 30 (Select this if the maximum power
of the speaker is less than 50 W to prevent them from
damaging the speaker.)
Off: Deactivates the built-in amplifier.
You can determine the use of LINE IN and VIDEO IN jacks on this
receiver.
Audio+Video: [Initial]; Select this when connecting an AV
component such as a VCR.
Audio: Select this when connecting an audio component
such as a cassette deck.
4
Camera* : Select this when connecting the rear view camera.
The rear view through the camera is automatically
displayed on the monitor when you change the gear
to the back position.
4
Camera Rev.* : The mirror image of the rear view through the
rear view camera is automatically displayed on
the monitor when you change the gear to the back
position. (The monitor on the unit only; the normal
rear view appears on the external monitor.)
47