Finishers; Cutter; Batch Takeup; Self-Strip Printing - Intermec EasyCoder 3400e User Manual

Appendix A— Specifications

Finishers

Parallel Interface Pin Descriptions

72
C d 39

Cutter

Use the cutter option to cut continuous media into individual labels ready
for use. This 3400 option works best for individual random lengths or
short batches of different label lengths.

Batch Takeup

This device automatically spools labels as they are printed. This
attachment is limited to small batches with maximum outer diameter
(OD) of 12.7 centimeters (5 inches).

Self-Strip Printing

Use self-strip printing in applications where you want to apply labels to a
surface immediately. After printing a label, the printer prints out the label
with the backing removed. This option must be ordered when you order
your printer.

Kanji/Katakana

This option allows the printer to print Japanese characters in two Kanji
fonts and three Katakana fonts. This option also provides increased storage
capacity.

Memory Expansion

You can install a flash SIMM module into the SIMM socket on the main
PCB to hold more fonts or bitmap graphics. You can also install a DRAM
SIMM to increase the image buffering capabilities of the printer. You can
purchase either module in 8 or 16 MB sizes only.
The following table lists the pin descriptions for the printer's parallel
interface connector.
Parallel Interface Pin Descriptions
Signal Pin Return
DATASTB 1 19
DB0 2 20
DB1 3 21
DB2 4 22
DB3 5 23
Helvetica CondensedHelvetica
Direction Description
IN Negative pulse. Latches DB0-7 on
the rising edge. Eight bits in parallel
provide data input. High is logical 1
and LOW is logical 0.
IN
IN
IN
IN
EasyCoder 3400e Bar Code Label Printer User's Manual