Troubleshooting - Intel D845GLVA Quick Reference

The following table describes the jumper block settings for the BIOS Setup
configuration jumper.
BIOS Setup Configuration Jumper Block (J9H2) Settings
Jumper Setting Mode
Normal (default)
1-2
3 1
Configure
2-3
3 1
Recovery
None
3 1
*To update or recover the BIOS, see the instructions in the Intel Desktop Board D845GLVA
®
Product Guide on the Intel Express Installer CD-ROM
For a complete list of BIOS Setup settings, see:
•
The Intel Desktop Board D845GLVA Product Guide on the Intel Express
Installer CD-ROM
•
The Intel World Wide Web Site at:
http://support.intel.com/support/motherboards/desktop/

Troubleshooting

Desktop Board D845GLVA system fails to boot.
•
Ensure that the power supply cable with the 4-pin connector is plugged into
the 12 V processor core voltage connector located near the processor socket
on the desktop board.
•
Remove and re-insert the Intel Pentium 4 processor or Celeron processor,
memory, and any add-in cards to make sure they are fully seated. Remove
any non-essential hardware components and boot the system.
•
Disconnect all power and remove the CMOS battery. Wait 10 minutes,
then re-install the battery, reconnect power, and boot the system.
A repeating beep error code is heard and the desktop board does not boot
or show any video.
This beep code may indicate a problem during detection of the DDR SDRAM
memory device. Check to ensure that system memory is properly installed and
that the DIMMs meet the Memory Module Requirements listed in the Supported
Components section of this document.
Resolving slow IDE boot times.
Extended boot time can be the result of IDE drive jumper configuration. For
additional information, visit
http://support.intel.com/support/motherboards/desktop/slowboot.htm
16
Description
The BIOS uses the current configuration and
passwords for booting.
After the Power-On Self-Test (POST) runs, the
BIOS displays the Maintenance Menu. Use
this menu to clear passwords.
The BIOS recovers data from a recovery
diskette in the event of a failed BIOS update.*
.
Intel Desktop Board D845GLVA Quick Reference