Playback; Quick Select Function - Denon AVR-3311 Owner's Manual

ENGLISH

Playback

1
Switch ZONE SELECT
"ZONE2" or "ZONE3".
The remote control unit switches to the
operating mode for ZONE2 or ZONE3.
2
Press AMP .
3
Press ZONE/DEVICE ON to turn
on the ZONE2 or ZONE3 power.
The or indicator on the
display lights.
• Also press input source select button when
in standby mode, the power turns on.
ZONE/DEVICE OFF
• When is pressed,
ZONE2 or ZONE3 turns off.
• Power in ZONE2 or ZONE3 can be turned
ZONE2 ON/OFF
on or off by pressing
ZONE3 ON/OFF
on the main unit.
4
Press the input source select button.
The audio signal of the selected source is output to ZONE2 or
ZONE3.
SOURCE SELECT
• Turn after
ZONE2/3 / REC SELECT
pressing
on the main unit to select an
input source.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select "MAIN" in step 1 then
ZONE/DEVICE OFF
press .
58
Adjusting the volume
to
VOL df
Use to adjust the volume.
GAdjustable rangeH – – –
(When the "Volume Display" (vpage 82) setting is "Relative")
GAdjustable rangeH
(When the "Volume Display" (vpage 82) setting is "Absolute")
• At time of purchase, "Volume Limit" (vpage 82) is set to "–10dB
(71)".
Input source
select buttons
MASTER VOLUME
Turn
main unit to adjust the sound volume.
Turning off the sound temporarily
MUTE
Press .
or
The sound is reduced to the level set at "Mute Level" (vpage 82) in
the menu.
• To cancel, either adjust the volume or press
• The setting is canceled when the zone's power is turned off.
You can adjust the tone and volume for ZONE2 and ZONE3 in "Zone
Setup" (vpage 81) in the menu.
–80dB – –40dB – 18dB
0 – 41 – 99
ZONE2/3 / REC SELECT
after pressing on the
MUTE
again.

Quick select function

It is also possible to save three settings for ZONE2.
n Saving the settings
1
Set the items below to the settings
you want to save.
q Input source (vpage 58)
w Volume (vpage 58)
2
Switch ZONE SELECT to
"ZONE2" or "ZONE3".
The remote control unit switches to the
operating mode for ZONE2 or ZONE3.
3
In the zone mode for which
you want to operate, press and
hold the desired QUICK SELECT
until "Memory" appears on the
display.
The current settings will be memorized.
GQuick select defaultsH
Input source
Z2/Z3 QUICK SELECT 1 BD
Z2/Z3 QUICK SELECT 2 SAT/CBL
Z2/Z3 QUICK SELECT 3 DOCK
n Recalling the settings
1
Switch ZONE SELECT to
"ZONE2" or "ZONE3".
The remote control unit switches to the
operating mode for ZONE2 or ZONE3.
2
Press QUICK SELECT at which the
settings you want to call out are
saved.
Naming quick select settings
See "Quick Select Name" (vpage 83).
Volume
–40dB
–40dB
–40dB