VTech CD1261 User Manual page 28

Appendix
Troubleshooting
My telephone cannot store numbers in memory.
• Make sure you press the correct sequence of buttons for storing numbers.
• If you do not press any key in 10 seconds when programming an entry, the procedure
will time out and you need to begin the operation again.
Try calling the number to be stored in memory. When the call ends, press PROG,
•
PAUSE/
REDIAL
location (0 through 9).
My handset screen is blank.
• Make sure the telephone handset cord is properly connected to the handset and the
telephone base.
• Make sure the telephone line cord is properly plugged into the telephone wall jack.
• Make sue you use only four AA alkaline batteries.
• Make sure four AA alkaline batteries are installed correctly (page 5).
Common cure for electronic equipment.
If your telephone does not seem to be responding normally, try putting the handset in its
base. If it does not seem to respond, do the following (in the order listed):
• Unplug the telephone line cord from the telephone wall jack.
• Remove the batteries from the battery compartment.
• Wait a few minutes.
• Place the batteries back into the battery compartment and then place the corded
handset back.
• Plug the telephone line cord into the wall jack.
, then a one-touch button (M1, M2 or M3), or MEMORY and a memory
25