Storage; Winter Storage; Service - Husqvarna SG 13 B Operator's Manual

Winter Storage

At the end of the season, the machine should be
readied for storage (or if it will not be in use for longer
than 30 days). Fuel allowed to stand for long periods
of time (30 days or more) can leave sticky residues
that can plug the carburetor and disrupt engine
function.
Fuel stabilizers are an acceptable option as regards
sticky residues during storage. If alkylate gasoline
(Aspen) is used, stabilizers are unnecessary because
this fuel is stable. However, you should avoid
switching between regular and alkylate gasoline
as sensitive rubber components can harden. Add
stabilizer to the fuel in the tank or in the storage
container. Always use the mixing ratios specified by
the manufacturer of the stabilizer. Run the engine for
at least 10 minutes after adding the stabilizer so that it
reaches the carburetor. DO NOT empty the fuel tank
and the carburetor if you have added stabilizer.

Service

When ordering spare parts, please specify the
purchase year, model, type, and serial number.
Always use genuine Husqvarna parts.
An annual check-up at an authorized service
workshop is a good way to ensure that your machine
performs its best the following season.
To ready the machine for storage, follow these steps:
1. Clean the machine carefully, particularly the
chassis and working equipment. Touch up
damage to the paint to prevent rust.
2. Inspect the machine for worn or damaged parts
and tighten any nuts or screws that may have
become loose.
3. Change the engine oil; dispose of properly.
4. Open the fuel valve. Empty the fuel tank (1) and
the carburetor (2).
5. Close the fuel valve.
6. Remove the spark plug and pour about a
tablespoon of engine oil in the cylinder. Turn over
the engine so that the oil is evenly distributed and
then refit the spark plug. Put the engine in the
compression phase where the triangle mark on
the sleeve of the starter is aligned with the upper
hole in the starter. Note: Compression phase
occurs every second revolution.
7. Lubricate all grease nipples, joints and cables as
described in Lubrication.
8. Store the machine in a clean, dry place and cover
it for extra protection.
9. Cover the blade and cutters with a thin coat of oil
to avoid rust.
48 -
HUSQVARNA

STORAGE

2
WARNING!
NEVER store an engine with fuel
in the tank indoors or in poorly
ventilated spaces where fuel vapor
can come in contact with open flame,
sparks or a pilot light such as in a
boiler, hot water tank, clothing drier,
etc. Handle the fuel with caution. It
is very flammable and careless use
can cause serious damage to person
and property. Drain the fuel into an
approved container outdoors and
far away from open flame. NEVER
use gasoline for cleaning. Use a de-
greaser and warm water instead.
1
8011-130
8011-131