Drive Belt
1.
Remove the belt guard by removing the three
acorn nuts and lockwashers on the front of the belt
guard.
WARNING!
Prevent the engine from being
started by removing the ignition
cable from the spark plug.
2.
Check that the belt is properly tensioned by
squeezing the belt together. It should be possible
to squeeze the belt down about ¼ -
mm) from the original position.
3.
Loosen screws holding cover plate to belt guard
backing plate.
4.
Undo the two screws (A) on each side of the
cutting shroud.
MAINTENANCE
/
" (6 - 10
3
8
COVER PLATE
HUSQVARNA
8060-226
8060-227
SCREWS
8062-006
-39