Maintenance; Maintenance Schedule - Husqvarna SG 13 B Operator's Manual

Maintenance Schedule

The following is a list of maintenance procedures
that MUST be performed on the machine. For those
points not described in this manual, visit an authorized
service workshop.

MAINTENANCE

Check engine oil level
Change engine oil
1)
Check air filter
Clean air filter
2)
Replace air filter cartridge
Clean sludge reservoir for fuel system
Check and clean spark plug
Replace spark plug
Check engine switch function
Check idle speed
Check and adjust play in valves
Clean fuel tank
4)
Check, replace fuel lines as necessary
Check throttle and cable
3)
Check blade and cutter
3)
Check decals and warning signs
Check wear and tension on belts
Check chassis, bolts and set screws
Grease the blade bearings (use high temperature grease
such as Mobilith SHC 220 or equal)
Grease the wheels (standard lithium base)
Check tire air pressure (25 psi max)
First change after 20 hours.
1)
Performed by authorized service workshop.
4)
MAINTENANCE
2)
3)
4)
4, 5)
3)
3)
6)
In dusty conditions maintenance is required at shorter intervals.
2)
Performed every second year.
5)
WARNING!
No service operations may be
performed on the engine or unit
unless:
The engine is stopped.
The ignition cable has been removed
from the spark plug.
The machine is securely parked
where it will not tip or begin rolling.
MAINTENANCE INTERVALS - MONTHS/HRS
Daily -/10 1/25
n
n
n
n
n
n
n
n
n
n
n
Grease every 4 hours.
6)
3/50 6/100 12/300
n
n
n
n
n
n
n
n
n
n
Before each use.
3)
-33
HUSQVARNA