Fluff Filters - Electrolux EDC67550W User Manual

Drying results unsatisfac-
tory.
When a button is pressed
- no reaction of the ma-
chine.
Displayed programme
time changes erratically or
stays unchanged for a
long time.
Programme inactive,
CONTAINER display illu-
minated.
Drying cycle ends shortly
after programme starts.
ANTICREASE (ANTI-
CREASE) light is on.
Drying cycle lasts an un-
usually long time. Note:
After up to 5 hours the
drying cycle ends auto-
matically (see 'End of dry-
ing cycle').
Discoloration
Have you pressed the START/
PAUSE (START/PAUSE) button?
Wrong programme selected.
Lint filters clogged.
Fluff filter clogged.
Heat exchanger clogged with lint.
Overloading of laundry.
Ventilation slots in base area cov-
ered up.
Residue on inside surface of drum
or drum ribs.
Conductance of water at installa-
tion site differs from standard set-
ting of machine.
Drying protection. After the start of
the programme, the option can no
longer be set.
Programme time is corrected auto-
matically depending on type and
volume of laundry and level of
dampness.
Condensate tank is full.
Not enough washing loaded or
washing loaded is too dry for selec-
ted programme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room temperature.
Temporary switching off of the
compressor to avoid overload.
Colour fastness of textiles.
Press the START/PAUSE (START/
PAUSE) button again.
Select a different programme the
next time you dry (see "Programme
overview" chapter).
Clean lint filters.
Clean fluff filter.
Clean heat exchanger.
Observe recommended loading
volumes.
Uncover ventilation slots in base
area.
Clean inside surface of drum and
drum ribs.
Re-programme standard setting for
degree of drying (see 'Program-
ming options' chapter).
Turn the programme knob to O
off . Set the programme again.
Automatic process; this is not a
machine fault.
Empty condensate tank, then start
programme with START/PAUSE
(START/PAUSE) button.
Select time programme or higher
drying level (e.g. EXTRA (EX-
TRA) instead of CUPBOARD
(CUPBOARD).
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately spun.
Automatic process, there is no fault
with the appliance. If possible, low-
er the room temperature.
Check colour fastness of textiles.
Only treat textiles together if they
are a similar colour.
electrolux 13