Cleaning And Maintenance - Electrolux EDC67550W User Manual

10 electrolux
Putting in extra items or taking items out
before end of programme
1. Open loading door.
Warning! Laundry and drum can
become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audi-
bly lock.
4. Press the START/PAUSE (START/
PAUSE) button to continue the drying cy-
cle.
Drying cycle complete / removing
laundry
Once the drying cycle is complete, The lights
ANTICREASE/END (ANTICREASE/END),
filter and full tank illuminate. If the Buz-
zer (Buzzer) button has been pressed, an
acoustic signal sounds intermittently for
about one minute.
The drying cycles (except from the
WOOL (WOOL) programme) are auto-
matically followed by an anti-crease

Cleaning and maintenance

Cleaning lint filters
To ensure that the appliance works perfectly,
the lint filters in the door and in front of the
drum must be cleaned after every drying cy-
cle.
Caution! Important. Never operate the
dryer without the lint filter or with a
damaged or blocked lint filter.
1. Open loading door
2. Use a damp hand to clean the micro- fine
filter, which is built into the lower part of
the loading aperture.
phase which lasts around 30 minutes.
The drum rotates at intervals during this
phase. This keeps the laundry loose and
free of creases. The laundry can be re-
moved at any time during the anti-
crease phase. (The laundry should be
taken out towards the end of the anti-
crease phase at the latest to prevent
creases from forming.)
1. Open door.
2. Before removing the laundry, remove fluff
from the micro-fine filter. It is best to use
a damp hand for this purpose. (See
"Maintenance and cleaning" chapter.)
3. Remove laundry.
4. Turn the programme selector to
Important! After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter "Maintenance and clean-
ing ".)
5. Close the door.
3. After a period of time, a patina due to de-
tergent residue on laundry forms on the
filters. When this occurs, clean the filters
with warm water using a brush. Remove
the filter from the door pulling it out. It can
be positioned with the tooth facing to the
left or to the right). After cleaning do not
forget to put it back.
4. Remove fluff from lint filter, preferably us-
ing a damp hand for this purpose.
5. Replace the filter.
off .