Stanley P2350S Owner's Manual page 9

Gas pressure washer
Table of Contents

Advertisement

DANGER
Pressure Washer Clearance
Exhaust heat/gases can ignite combustibles, structures or
damage fuel tank causing a fire.

Keep at least 5 ft. (152 cm) clearance on all sides of pressure
washer including overhead.
Place pressure washer in a well ventilated area, which will allow for
removal of deadly exhaust gas. DO NOT place pressure washer where
exhaust gas could accumulate and enter inside or be drawn into a
potentially occupied building. Ensure exhaust gas is kept away from
any windows, doors, ventilation intakes or other openings that can
allow exhaust gas to collect in a confined area. Prevailing winds and
air currents should be taken into consideration when positioning pres-
sure washer.
IMPORTANT: To avoid pump damage, you must assemble the nozzle extension
to the spray gun and attach all hoses before you start the engine.
Step 8

Attach the Quick Connect Inlet coupling to the water supply inlet on
pressure washer, as shown in the Figure below.
Step 9

Add 0.75 quarts of SAW10-30 oil into the engine. Ensure dip stick
is dry before checking to avoid false readings. Wipe the dip stick
with a clean cloth put it into the engine and remove it. Then verify
the oil is filled up to the top mark on the dip stick. IMPORTANT:
VERIFY THE OIL IS FILLED UP TO THE TOP MARK ON THE
DIPSTICK.
Fill to Top
Mark
Rev: Dec2010
PREPARATION & ASSEMBLY
Recommendation on oil change.

Step 10

Step 11

Important:


®
STANLEY Electric Pressure Washers
The pump is integrated with the engine so it uses the same oil
(SAE10W-30). It is recommended that you change the oil every
20—30 hours of use or every 3 months. Failure to properly
maintain the pressure washer will cause pre-mature damage to the
pressure washer.
Add 0.75 gal (or until you reach the bottom of the neck) of unleaded
gasoline. DO NOT OVERFILL.
Attach garden hose to water supply.
Note: DO NOT turn on the water yet.
Never turn the engine on without having the water turned on.
Running the pump with no water can cause pre-mature pump
damage.
9 of 18

Advertisement

Table of Contents
loading

This manual is also suitable for:

P2750sP2350s-canP2750s-can

Table of Contents