Stanley P2350S Owner's Manual page 14

SHUTTING DOWN AND CLEANING UP
Step 1
1. Let engine idle for two minutes. Turn the switch to "OFF" (0)
position and unplug cord from outlet.
Step 2
Turn off the water supply.
Step 3
ALWAYS point gun in a safe direction and then press trigger to
release water pressure for 20~30 seconds.
IMPORTANT!
Simply shutting OFF engine will not release pressure in the
system. When the engine has shut down, press the trigger on the
spray gun to relieve the pressure in the hose.
WARNING
Turn OFF water supply and squeeze trigger to depressurize
the unit. Failure to do so could result in personal injury due
to discharge of high-pressure water.
14 of 18
OPERATION
Step 4
Disconnect the garden hose from the water inlet on the unit.
Step 5
Disconnect the high-pressure hose from the high pressure outlet
and engage the gun safety lock.
STEPPING AWAY OR TAKING A BREAK
If taking a break of five minutes or more:
1. Engage gun safety lock.
2. Turn pressure washer to "OFF" (O) position.
IMPORTANT: Simply shutting OFF engine will not release
pressure in the system. When the engine has shut down, squeeze
the trigger on the spray gun to relieve the pressure in the hose.
®
STANLEY Electric Pressure Washers
Rev: Dec2010