Stanley P2350S Owner's Manual page 7

WARNING
Rapid retraction of starter cord (kickback) will pull hand and
arm toward engine faster than you can let go. Broken bones,
fractures, bruises or sprains could result.

ALWAYS point gun in safe direction and squeeze spray gun trigger, to
release pressure and avoid kickback each time, before starting engine.
Engage trigger lock when not in use.

When starting engine, pull cord slowly until resistance is felt and then
pull rapidly to avoid kickback.

After each starting attempt, where engine fails to run, always point gun in
safe direction and squeeze spray gun trigger to release high pressure.
WARNING
Running engines produce heat. Temperature of muffler and nearby
areas can reach or exceed 150°F (65°C).
Severe burns can occur on contact.
Exhaust heat/gases can ignite combustibles, structures or damage fuel
tank causing a fire.

DO NOT touch hot surfaces and avoid hot exhaust gases.

Allow equipment to cool before touching.

Keep at least 5 ft. (152 cm) clearance on all sides of pressure washer
including overhead.

Code of Federal Regulation (CFR) Title 36 Parks, Forests, and Public Prop-
erty require equipment powered by an internal combustion engine to have
a spark arrester, maintained in effective working order, complying to
USDA Forest service standard 5100-1C or later revision. In the State of
California a spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
WARNING
Recoil starter and other rotating parts can entangle hands, hair, cloth-
ing, or accessories.

DO NOT wear loose clothing, jewelry or anything that may be caught in
the starter or other rotating parts.

Tie up long hair and remove jewelry.
WARNING
High pressure spray can cause paint chips or other particles to be-
come airborne.

Always wear eye protection when using this equipment or in vicinity of
where equipment is in use.
Rev: Dec2010
Warnings
Unintentional sparking can result in fire or electric shock.
WHEN ADJUSTING OR MAKING REPAIRS TO YOUR
PRESSURE WASHER

WHEN TESTING FOR ENGINE SPARK


The high pressure stream of water that this equipment produces can
pierce skin and its underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when engine is stopped
and water is disconnected, which can cause injury.






Excessively high or low operating speeds increase risk of injury and
damage to pressure washer.


®
STANLEY Electric Pressure Washers
WARNING
Disconnect spark plug wire from spark plug and place wire where it
cannot contact spark plug.
Use approved spark plug tester.
DO NOT check for spark with spark plug removed.
WARNING
NEVER aim spray gun at people, animals or plants.
DO NOT allow CHILDREN to operate pressure washer.
NEVER repair high pressure hose. Replace it.
NEVER repair leaking connections with sealant of any kind. Replace o-
ring or seal.
Keep high pressure hose connected to pump and spray gun while system
is pressurized.
ALWAYS point gun in safe direction and squeeze spray gun trigger, to
release high pressure, every time you stop engine. Engage trigger lock
when not in use.
CAUTION
DO NOT tamper with governed speed.
DO NOT operate pressure washer above rated pressure.
7 of 18