Table of Contents
Advertisement
2.2.3
Connecting a Floppy Drive
Figure 22.
Floppy Drive Connector
In order to connect a floppy drive, plug the cable into the socket shown in
guiding the keyed plug into the keyed socket. Connect the other end of this cable to the
floppy drive and providing it power from the power supply.
2.2.4
Changing and/or Updating the BIOS Chip
In order to change the BIOS chip (see
located in
component called out as number 32) without damaging the pins use an EEPROM chip
removal tool. Remove the BIOS chip by inserting the pinchers of the tool in each open
corner of the socket, close the pinchers around the chip and pull the chip out carefully.
Use a BIOS burn-in tool to update the firmware, then reinsert the chip by aligning the
dot on the BIOS chip with the triangle on the socket and gently pressing the chip into
place.
Figure 23.
Firmware Hub
User's Manual
32
Section 2.2.4, "Changing and/or Updating the BIOS Chip" on page 32
Figure 23, "Firmware Hub" on page
Platform Setup
Figure 22
by
32, which is
and is
June 2007
Order Number: 316639-002
Advertisement
Table of Contents
