Chapter Six Reference; Itroubleshooting - Roland GP-16 Owner's Manual

Chapter Six Reference
dl---T-r-o-u-bl-e-sh-o-o-ti-n-g----,
The lollowing provides inlormalion on what to do, or
where to reler to when the GP-16 does not operate as
expected.
• No sound produced
Are you sure none
01
your cables are damaged?
Have you checked ali connections made with ex-
ternal devices?
- ":1 IMaking Conneclions" (1&P 9)
Check that volume
01
amp, mixer, or other device
is not turned down.
Does the "Input Level Indicator" lighl when the
guitar is played?
-
"[~J Adjustment of Input Level" (""'P,12)
Have you checked the patch to see il all settings
are correct? (For example, Master Volume could
be al
"0")
Is there an amplifier connected to the channel
specified under "Output Select".
- "c. OUlput Select" ("'"P,22)
- "11, Cancellallon of Output Seleel" (""P,53)
Have you made sure the level hasn't remained
- Sel it to the "RRC Foot Pedal Mode" after
relerring to the FC-100MKII's Owner's Man-
uaL
Are you sure you are In the PLAY mode?
- Periorm '7. Escaping" (""'P.23)to gel to the
PLAY mode,
• The foot controller's "Control pedal"
doesn't operate as expected.
Check that you have the Mode Selection switch
on the loot controller set to "MODE I" .
.. "2, Settings related to the loot controller"
(""P,15)
Are the control pedals lunctions set properly?
- "10, Setting the Function 01 the Control Pedal"
(""'P,53)
• The expression pedal doesn't operate as
expected.
Is the "Minimum Volume"lorthe expression pedal
set to the lowest level?
Are patch contents set properly?
... "b. Expression Pedal" (S'P,20)
low as a resull
01
the expression pedal? •
MIDI doesn't function
.. Output channels cannot be used as
expected.
Has the setting lorlhe palch been made properly?
. . "0.
Output Select" ("'-P .22)
Has Output Select been left in its cancelled state?
- "11. Cancellation 01 Output Seleel" (""'P.53)
.. Patches cannot be selected from the panel.
Are you sure you are in the PLAY mode?
.. Periorm '7. Escaping "(""P.23) to get to the
PLAY mode,
.. Patches cannot be changed using a foot
controller.
Check that Ihe RRC cable is connected securely.
Are you sure that the loot controller is operating
property?
Wilh an FC-1 00 MKII, check if
it
is set to the "RRC
FoOl Pedal Mode" .
Do the MIDI channels on the connected devices
match?
- "1. Set1ingthe MIDI Receive Channel"(""'P
.47)
- "2,SettingtheMIDITransmitChannel"(",p,47)
.. Program Changes don't work as expected.
Have checked that MIDI Mapping has been set
property?
.. "7, MIDI Mapping (Program Change -> PatCh)"
(""'P,52)
... "8, MIDI Mapping (Patch -> Program Change)"
(gP.S2)
.. Master Volume cannot be controlled using
Control Change messages.
Is "MIDI Filter' set as
n
should be?
- ''9. MIDI Filter" (""'P.53)
.. The display character is not clearly be
seen.
Adjust the display'S contrast
- "12. LCD Contrast" ("""P.53)
55
6
-