Clearances To Combustibles - Lennox Hearth Products Vintage VIN Installation And Operation Manual

Clearances to Combustibles

Minimum clearances to combustible materials shown here are in inches
(millimeters). See Pages 7 and 8 for pipe clearances.
Parallel Installation
(102mm)
Figure 4
Corner Installation
(270mm)
4"
(102mm)
Figure 5
Floor Protection
A non-combustible hearth pad is not required. This stove may be installed
on a combustible surface as long as the combustible material (such as
carpeting) does not extend 1-1/2" vertically above the bottom of the legs
(see Figure 6). Also, the floor beneath the stove must be stable, level, hard
and strong enough to support the stove without a tipping hazard.
1-1/2" (38mm)
Maximum
Figure 6
8
Combustible Wall
15-1/4"
4"
(387mm)
(102mm)
4"
˚
90
10-5/8"
13-7/8"
(352mm)
(102mm)
Carpet
Leg
Leg on Combustible
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Alcove dimensions
The minimum width between alcove side walls is 30-1/2" (775mm). The
glass door lifts up to access the firebox on the stove. Therefore, if the stove
is to be installed in an alcove, the alcove needs to be constructed to allow
for removal of the glass door. Option 1: The maximum alcove depth is
15" (381mm) (maintaining a 4" [102mm] rear clearance the stove will be
positioned partly into the room) and the remaining minimum dimensions
to combustibles are as shown in the Option 1 drawing below. Option 2:
The alcove is 43" (1092mm) high to provide sufficient space to remove
the door. The maximum depth of the alcove is 24" (610mm). Option 3:
Should an alcove depth from 2 feet (.61M) to 4 feet (1.22M)be desired
then the minimum alcove height is 54" (1372mm). Access to the stove's
controls should be considered when determining the alcove size.
Alcove
Option 1
4"
Figure 7
Alcove
Option 2
Figure 8
Alcove
Option 3
Figure 9
40"
33" 1016mm
838mm
15"
381mm
30-1/2"
775mm
24"
610mm
30-1/2"
775mm
1372mm
48"
1219mm
30-1/2"
775mm
42"
1067mm
43"
1092mm
54"