Pre-Installation; Features; Packaging List; Ratings - Lennox Hearth Products Vintage VIN Installation And Operation Manual

PRE-INSTALLATION

Features

Installation Options
Residential
Vented vertical and horizontal
Manufactured (mobile) home
Natural gas (NG) or propane (LP)
Bedrooms
Optional wall-mounted or remote thermostat
Venting
This stove can be vented with Security™ Secure Vent™ pipe*. Coaxial
pipe diameters are 6-5/8" outer and 4" inner. The combustion air for this
stove is drawn from outside the house through the outer DV (direct-vent)
pipe. Room air is not required for combustion.
When planning your installation, select the correct length of vent pipe
for your particular requirements. Determine the minimum clearance to
combustibles from the rear of the unit to the wall. It is also important
to note the thickness of the wall. Before cutting the vent hole through
the wall make sure that ALL vent and termination clearances (see Page
16) will be met.
Electrical
The standard fan motor requires 120 Volts AC for operation. The stove is
not dependent on the fan or an outside electrical supply to operate.
WARNING - Electrical Grounding Instructions - This appliance is
equipped with a three-prong (grounding) plug for your protec-
tion against shock hazard and should be plugged directly into a
properly grounded three-prong receptacle. Do not cut or remove
the grounding prong from this plug.
* Other approved chimney brand is Simpson Dura-Vent DV-GS.
Max/Min Input BTUh 0-2,000 Feet
(0-610 M)
u
Manifold Pressure (IN. WC)
Min. Inlet Pressure (IN. WC)
Maximum heat output BTUs/hour-steady state
P4 Efficiency
Orifice (DMS) 0-2,000 Feet (0-610 M)
Unit factory equipped for 0-2000 FT/0-610 M, In Canada 0-4500 FT/0-1370 M
u
The Steady State Efficiency numbers based on maximum vent configuration.
v
Tested to CSA P.4.1-02 "Testing Method for Measuring Annual Fireplace Efficiency.
w
Electrical Rating: 120 VAC, 60 HZ, Less Than 2 Amps
6

RATINGS

w
u
Millivolt Valve
This stove is operated with a millivolt valve and therefore burns even
during a power outage.
Fuel
This stove comes from the factory equipped to burn natural gas at a specified
elevation. The stove can be converted to burn LP gas (liquid propane) by
changing the cassette (valve and pilot assembly) or installing a conversion
kit. Only Lennox Hearth Products conversion kits can be used to convert
from NG to LP or LP to NG. Contact your Lennox Hearth Products dealer
for details.
Specifications
Stove weight: 150 lbs
Pipe:Type - direct-vent
Recommended manufacturer*
Security™ Secure Vent™*
Diameter - 6-5/8"x 4" for all installations
Stove Packaging List
The Vintage™ gas stove comes with the following parts:
1 Stove Body with Burner Cassette
1 Log Set
1 Bag of Ember Material
1 Bag of the volcanic stone.
1 Installation and Operation Manual
Optional Parts
150 CFM Blower
Reversible Cast-Iron Panels
Gallo Veneziano Stone Panels
Soapstone Panels
Remote Controls
Digital Wall Thermostat Kit
Note: See Page 27 for ordering information.
Vintage™ (VIN)
NATURAL GAS
27,000 / 19,500
3.5 / 1.8
5.0
22,140
47.00%
#40/.098 IN.
LP GAS
27,000 / 21,300
10.0 / 6.0
11.0
22,140
49.07%
#53/.060 IN.