SiUS041111
2.4
Removal of Electrical Box / PCBs / Swing Motors
Procedure
Step
1. Remove the electrical box.
1
Remove the screw and
remove the drip proof
plate.
2
Cut the clamp.
3
Pull out the indoor heat
exchanger thermistor.
4
Remove the screw of
the ground.
5
Remove the screws of
the connection wires.
Removal Procedure
Warning
Be sure to wait for 10 minutes or more after turning off all power supplies
before disassembling work.
Procedure
Indoor heat exchanger thermistor
Ground
Preparation
Remove the front grille
according to the "Removal of
Front Grille".
Drip proof plate
(R2771)
(R14685)
Be careful not to lose the clip for
the thermistor.
Connection
wires
(R14686)
Indoor Unit: 15/18/24 Class
Points
Clip
(R11234)
157