Dmx Control; Loss Of Signal Setting; Zoom Limit Setting - Chauvet Colorado 2 Zoom Tour User Manual

Operation

DMX Control

Loss of Signal
Setting
Zoom Limit
Setting
-10-
In this mode, each product will respond to a unique starting address from the DMX
controller. All products with the same starting address will respond in unison.
1. Select a DMX personality as shown in
2. Set the running mode:
a. Go to the RUN main level.
b. Select the DMX programming level.
3. Set the starting address:
a. Go to the DMX main level.
b. Select the starting address (001~512).
The highest recommended starting addresses for each DMX mode are as follows:
DMX Mode DMX Address
TOUR
501
ARC.1 510
AR1.D 509
This setting controls how the product will respond when the DMX signal is lost.
1. Go to the SET main level, then select DERR.
a. Select SAVE to make the product use the last command used when the signal is
lost.
b. Select BLAC to turn off the all the LED's when the signal is lost.
This setting allows you to limit the zoom range using three (3) different modes.
Basic mode is the default setting and allows the zoom to be moved full range (0~255) and
has no adjustable limit.
Position 1 and position 2 modes allow you to set limits on how far the zoom moves.
1. Set the mode to be used:
a. Go to the SET main level.
b. Select ZOOM
c. Select a mode (BASE, POS.1, or POS.2).
2. Set the limit for each mode:
a. Go to the CAL main level.
b. Enter the master access password as described in
c. When CAL shows, press <UP>.
d. Go to the ZOOM.
e. Select a mode (POS.1 or POS.2).
f. Select a zoom limit value (P.000~255).
DMX Personality.
DMX Mode DMX Address
ARC.2
509
AR2.D 508
COLORado™ 2 Zoom Tour User Manual Rev. 01
DMX Mode DMX Address
HSV
510
AR2.S 507
Control Panel Lock