Connecting the Wiring
Follow
Figure 1
to connect the video output connector (#a) and 24 VAC/12
VDC power connector (#b).
Note
For DC power supply use, make sure the polarity is correct to
avoid malfunction and/or camera damage.
Mounting the Camera
1.
Place the supplied mounting template (#2 on
mounting surface and mark the holes.
2.
Drill two holes, then insert the screw anchors (#1) into the holes.
3.
Remove the camera housing, if you have not already done so.
4.
Secure the camera base to the wall or ceiling with the TP4 x 15 mm
tapping screws supplied (#3).
Note
Depending on the material of your mounting surface, you may
require different screws and anchors than those supplied.
Document 800-05321 Rev B
05/10
Figure
3) on the
11