Adjusting the Camera
To adjust this axis ... Do this ...
Horizontal
Vertical
Horizontal for wall
mount and ceilings
Adjusting the Lens
Adjust this lever ...
Zoom lever (#3)
Focus lever (#4)
Re-tighten the Zoom and Focus levers after adjusting. Repeat this
procedure until the desired range and focus are set.
Important:
Lock the zoom and focus levers after making adjustments so
the positions don't move (for example, from temperature changes or
vibrations).
Document 800-05321 Rev B
05/10
Rotate the 3D gimbal assembly in the base.
Caution
Do not turn the gimbal assembly more than 360°
as this may cause the internal cables to twist and
disconnect or break.
1. Loosen the Tilt adjustment thumbnuts (see #1 on
Figure
5). Turn one Tilt adjustment thumbnut counter-
clockwise and one clockwise.
2. Turn the Tilt adjustment bracket (#1) and Axis ring (#2)
in the desired direction, then retighten the thumbnuts.
Rotate the lens base (maximum 360°) until you are satisfied
with the field of view.
To accomplish this ...
Turn the Zoom lever counter-clockwise a little, then rotate
the Zoom lever until you are satisfied with the image view.
Turn the Focus lever counter-clockwise a little, then adjust
the focus for optimum picture sharpness.
15