Power Management Setup - Abit UL8 User Manual

BIOS Setup

3-6. Power Management Setup

Phoenix – Award WorkstationBIOS CMOS Setup Utility
ACPI Suspend Type
- Resume by USB from S3
Power Button Function
Wake-Up by PME# of PCI
Resume by Ring
Wakeup by Alarm
X - Date(of Month) Alarm
X - Time (hh:mm:ss) Alarm
Cool'n'Quiet Technology
POWER ON Function
X - KB Power ON Password
X - Hot Key Power ON
Restore on AC Power Loss
↑↓:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
ACPI Suspend Type:
This item selects the type of Suspend mode.
[S1(PowerOn-Suspend)]: Enables the Power On Suspend function.
[S3(Suspend-To-RAM)]: Enables the Suspend to RAM function.
! Resume by USB from S3:
Two options are available: Disabled or Enabled. The default setting is Enabled. When set to Enabled, any
event affecting from onchip USB will awaken a system that has powered down. This item can be
configured only if the item "ACPI Suspend Type" is set to [S3(STR)].
Power Button Function:
Two options are available: Delay 4 Sec or Instant-Off. The default setting is Instant-Off. It is activated
when the user presses the power button for more than four seconds while the system is in the working
state, then the system will transition to the soft-off (Power off by software). This is called the power
button over-ride.
Wake-up by PME# of PCI:
Two options are available: Disabled or Enabled. The default setting is Enabled. When set to Enabled, any
event affecting from PCI card (PME) will awaken a system that has powered down.
Resume by Ring:
Two options are available: Disabled or Enabled. The default setting is Disabled. When set to Enabled,
any event affecting from Modem Ring will awaken a system that has powered down.
Power Management Setup
S3(Suspend-to-RAM)
Enabled
Instant-Off
Enabled
Disabled
Disabled
0
0 : 0 : 0
Enabled
BUTTON ONLY
Enter
Ctrl-F1
Off
F6: Fail-Safe Defaults
Item Help
F7: Optimized Defaults
User's Manual
3-19