Suspend Mode; Power On By Ring; Power On By Alarm - Abit LM6E Pentium II User Manual

Introduction of BIOS

Suspend Mode:

When the setting selected for "Power Management" is "User Define", you
can define for this mode any delay from 1 minute to 1 hour. If no power
management event occurs during this time period, meaning the computer
is inactive during this period, the system will enter the Suspend power
saving mode. The CPU stops working completely.
If this mode is disabled, the system will not enter the Suspend mode.
Throttle Duty Cycle:
This is used to specify the CPU speed in power saving mode. Seven
options are available: 12.5%, 25.0%, 37.5%, 50.0%, 62.5% or 75.0% .
IDE HDD Power Down:
If the system has not accessed data on the hard disk drive during the
specified time period, the engine of the HDD will stop in order to save
electricity.
You can set 1 to 15 minutes or select Disable according to your use of the
HDD.
Power Button Override:
Support ACPI Power Button Over-ride. The user presses the power
button for more then four seconds while the system is in the working
state, then the system will transition to the soft-off(Power off by
software). This is called the power button over-ride.
Resume by LAN :
To enable this feature , you must make sure your network software and
network adapter (LAN card) support such a function. This function is
also called " Wake on LAN " ( WOL) .

Power on by Ring:

If you connect an external modem to the onboard serial port, the system
will be turned on when a telephone ring-up occurs.

Power on by Alarm :

RTC alarm can turn on the system . You can set date ( of month ) and
time ( hour , minute , second ) .
3-25