Abit SG-71 User Manual page 58

4-8
Fifteen options are available: Floppy
HDD-3 ZIP100
Back to Floppy. The default setting is Floppy.
Second Boot Device:
Description is the same as the First Boot Device, the default setting is HDD-0.
Third Boot Device:
Description is same as the First Boot Device, the default setting is CDROM.
Boot Other Device:
Two options are available: Disabled
BIOS to try to boot devices other than the three which are listed in the above First, Second and Third
Boot Devices. If you set to Disabled, the BIOS will boot from only the three kinds of boot devices that
are set above.
Swap Floppy Drive:
Two options are available: Disabled
enabled, you don't need to open the computer case to swap the position of floppy disk drive connectors.
Drive A can be set as drive B and drive B can be set as drive A.
Boot Up Floppy Seek:
Two options are available: Disabled
boots up, the BIOS detects if the system has a FDD or not. When this item is set to Disabled, if the BIOS
detects no floppy drive, it will display a floppy disk drive error message. If this item is disabled, the BIOS
will skip this test.
Boot Up NumLock Status:
® Off: At boot up, the Numeric Keypad is in cursor control mode.
® On: At boot up, the Numeric Keypad is in numeric mode. (Default Settings)
Security Option:
This option can be set to System
password through Set Password at the CMOS setup main menu, this option will deny access to your
system (System) or modification of computer setup (BIOS Setup) by unauthorized users.
®SETUP:
When you choose Setup, a password is required only when accessing the BIOS Setup. If
the correct password is not given, you can't enter the BIOS setup menu. (Default setting)
®SYSTEM: When you choose System, a password is required each time the computer boots up. If the
correct password is not given, the system will not start.
To disable security, select Set Password at main menu and then you will be asked to enter password. Do
not type anything and just press the Enter key and it will disable security. Once security is disabled, the
system will boot and you can enter the BIOS setup menu freely.
SG-71
LS120
USB-FDD USB-ZIP
Enabled. The default setting is Enabled. This setting allows the
Enabled. The default setting is Disabled. When this feature is
Enabled. The default setting is Disabled. When the computer
Setup. The default setting is Setup. After you have created a
HDD-0 SCSI CDROM
USB-CDROM
HDD-1
USB-HDD LAN
Chapter 4
HDD-2
Disabled