Step 2. Installing The Ceiling Assembly - Carrier Air V Owner's Manual

STEP 2 - INSTALLING THE CEILING ASSEMBLY
Make sure that you have properly matched the roof top air conditioner and interior ceiling assembly. The following
step by step instructions must be performed in the following sequence to insure proper installation.
1
Carefully take the ceiling assembly out of the
carton. (The controls are factory installed in the
ceiling assembly.)
2
Remove the ceiling grille from the ceiling assembly
frame. And remove the heater assembly from the
ceiling assembly frame.
3
Before the ceiling assembly can be mounted to
the roof top air conditioner, the fabric duct collar
must be fastened to the basepan of the air
conditioner with 4 screws (See
4
Before lifting (mounting) the ceiling assembly, check
the gasket on the underside of the roof top air
conditioner. The gasket must be centered over the
roof opening.
, Figure 4).
SERIAL NUMBER
OF UPPER UNIT
SERIAL NUMBER
OF CEILING UNIT
5
Before lifting the ceiling assembly, pull the fabric
duct collar so it hangs out of the way and does
not get caught under the ceiling assembly frame.
6
Secure the ceiling assembly frame to the roof top
air conditioner with the mounting bolts (See
Figure 4). You must start (thread) the mounting
bolts by hand to avoid cross-threading. DO NOT
START THE MOUNTING BOLTS WITH AN AIR GUN.
The mounting bolts should be tightened evenly.
Do not over-tighten each bolt. The bolt tightening
process is complete when the basepan gasket
has been evenly compressed to 60%.
7
Pull the fabric duct collar through the ceiling
assembly frame opening and pull the four corners
to extend below the duct opening
(See , Figure 4).
'
OWNER S GUIDE - 9
,
Figure 4