Carrier Air V Owner's Manual page 9

Above Level 10 Max.
Below Level 0 Max.
ALLOWABLE OFFSET FOR CARRIER AIR CONDITIONERS
NOTE
ROOF TOP HEAT PUMP UNIT DIMENSIONS
WITH CARRIER ROTARY COMPRESSORS
* Height Varies
To Make Unit
Level
Figure 3
10.3"
14" x 14"
OPENING
41"
Above or Below
Level 10 Max.
• If the roof of the vehicle is sloped (not level) such that
the roof top air conditioner cannot be mounted within
the maximum allowable degree specifications, an
exterior leveling shim will need to be added to make the
Air V level. A typical leveling shim is shown in Figure 3.
• Once the roof top air conditioner has been leveled, some
additional shimming may be required above the interior
ceiling assembly. The roof top air conditioner and the
interior ceiling assembly must be square with each other
before they are secured together.
• After the mounting hole area is properly prepared,
remove the carton and shipping pads from around the
roof top air conditioner. Carefully lift the unit on top of
the vehicle. Do not use the outer plastic shroud for lifting.
Place the roof top air conditioner over the prepared
mounting hole.
• The pointed end (nose) of the shroud must face toward
the front of the vehicle. From inside the vehicle, pull the
electrical harness down from the roof air conditioner
through the mounting opening and let it hang.
16.7"
OWNER
Figure 2
REAR OF
UNIT
'
S GUIDE - 8