Dremel 4200 Operating/Safety Instructions Manual page 20

FIG. 7a
EZ Drum™ Mandrel No. EZ407SA has a
spring loaded sleeve and is used with sanding
bands.
1. Pull EZ Change™ levers down towards
unlock sign on the tool (Fig. 1). Place EZ
Drum™ mandrel (1) into EZ Change™ chuck
(2) as deep as possible (Fig. 2) and release EZ
Change™ levers to tighten (Fig. 3). Note:
there is a blue spacer (3) on the mandrel that
will bottom out on the EZ Change™ chuck,
setting the mandrel to the correct depth.
Always unplug rotary tool
WARNING
!
before changing accessories.
Incorrect seating of sanding band on mandrel
may lead to personal injury orproperty damage.
To load accessory:
2. As indicated, place two fingers underneath
FIG. 1
FIG. 3
3
FIG. 7b
90˚
the mandrel and pull firmly up. This will place
the EZ Drum™ in the "unlocked" position (Fig. 2).
3. Keeping two fingers beneath the mandrel,
slide the sanding band down until the entire
blue mandrel is covered (Fig. 3).
4. To return to "locked" position, press firmly
down on the top of the mandrel (Fig. 4).
Removing the sanding band on
1. Place two fingers underneath the mandrel
and pull firmly up. This will place the EZ
Drum™ in the "unlocked" position (Fig. 2).
2. Sanding band will now easily slide off
mandrel. (Do not squeeze sanding band when
removing from EZ Drum ™ mandrel. This can
lead to rubber band pulling off mandrel and
becoming inoperable (Fig. 4).
FIG. 2
2
FIG. 3
20
the mandrel:
1