Dremel 4200 Operating/Safety Instructions Manual page 18

Sanding Accessories
Sanding discs in fine, medium and coarse
grades are made to fit on a mandrel. They can
be used for nearly any small sanding job you
might have, from model making to fine furniture
finish ing. In addition, there is the drum sander,
a tiny drum which fits into the Rotary Tool and
makes it possible to shape wood, smooth
fiberglass, sand inside curves and other diffi cult
places, and other sanding jobs. You replace the
sanding bands on the drum as they become
worn and lose their grit. Bands come in fine
medium and coarse grades. Flapwheels grind
and polish flat or contoured surfaces. They are
used most effectively as a finishing sander after
heavier surface sanding and material removal
is completed. Flapwheels come in fine and
coarse grades. Buffs are a great finishing
accessory for cleaning and light sanding. They
work effectively on metal, glass, wood,
aluminum and plastics. Coarse and medium
buffs are sold together. All buffs are sold
individually. Do not exceed 15,000 RPM in
speed. 1/8" shank.
Grinding Wheel
Use for deburring, removing rust, and general
purpose grinding. Use with Mandrel #402.
Cutting Wheels
These thin discs of emery or fiberglass are
used for slicing, cutting off and similar
Dremel Accessories (Cont.)
operations. Use them for cutting off frozen bolt
heads and nuts, or to reslot a screw head
which has become so damaged that the
screwdriver won't work in it. Fine for cutting
BX cable, small rods, tubing, cable and cutting
rectangular holes in sheet metal.
Drywall Cutting Bit
Gives you fast, clean cuts in drywall.
Tile Cutting Bit
Cuts ceramic wall tile, cement board, and
plaster.
Spiral Cutting Bit
Cuts through all types of wood and wood
composites.
High Speed Router Bits
For routing, inlaying, and mortising in wood
and other soft materials. Use with Dremel No.
335 Router attachment and No. 231
Shaper/Router table.
The following drill bits (628, 660, 661) can only
be used with the 4200 if the 1/8" collet that
comes with the tool is changed with the collet
that matches the drill bit shank size (1/32" or
1/16" or 3/32").
The following chucks (4484, 4486) can not be
used with the 4200 due to the absence of a
threaded cone in the EZ Change™
mechanism.
18
Drill bits
3 Jaw Chuck