The Electrical Connections - AEG Electrolux ER 6422 T Instruction Booklet

The electrical connections

Warning
THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability
should this safety measure not be observed.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut off
and the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to
prevent the hazard of shocks in case it should
be plugged into a 13amp socket in another part
of your home.
Important
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow
Blue
Brown
If you fit your own plug, the colours of the wires
in the mains lead of your appliance ,ay not
correspond with the markings identifying the
terminals in your plug, proceed as follows:
- Connect the Green and the Yellow (earth) wire
to the terminal in the plug which is marked with
the letter «E» or the earth symbol
coloured green and yellow.
- Connect the blue (neutral) wire to the terminal
in the plug which is marked with the letter «N»
or coloured black.
- Connect the brown (live) wire to the terminal in
the plug which is marked with the letter «L» or
colured red.
The plug moulded onto the lead incorporates a
fuse. For replacement, use a 13amp BS1362
fuse. Only ASTA or BSI approved fuses should
be used.
The plug must not be used if the fuse
cover/carrier is lost. The cover/carrier is
indicated by the colured insert at the base of the
plug.
A replacement cover/carrier must be obtained
from your local Electrolux Service Centre whose
address is listed at the back of this instruction
manual.
- Earth
- Neutral
- Live
, or
GREEN & YELLOW
13 AMP. FUSE
BROWN
BLUE
CORD CLAMP
D207
Fig. 2
5