Installation; Positioning; Before Using; For Maximum Efficiency - AEG Electrolux ER 6422 T Instruction Booklet

Positioning

For this appliance to work efficiently, it should
be located away from heat sources, e.g.
cookers, radiators, boilers, direct sunlight etc.
This also includes locations or rooms where the
ambient temperature reaches above 32
degrees C or drops below 10 degrees (e.g.
conservatories).
You should also ensure that air can circulate
freely around the back and the top of the
cabinet. There must also be at least 100 mm
distance beween the top of the cabinet and any
overhanging kitchen furniture.
There should also be a gap of 25 mm either
side and at the top of the appliance. Do not
obstruct the space underneath. The back of the
cabinet may be placed close to the wall but
must not touch it. DO NOT install in places with
restricted ventilation.
Adjust the level of the appliance by screwing
out the adjustable foot, or feet, at the bottom of
the cabinet using your fingers or a spanner (see
Fig. 1).
Warning
If you are discarding an old appliance that
has a lock or catch on the door, you must
ensure that it is made unusable to prevent
young children being trapped inside.
This appliance complies with the E.E.C.
Directive No. 87/308 of 2.6.87 relative to
radio interference suppression.
This appliance complies with the
following E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive)
and subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
4

INSTALLATION

Before using

Remove all securing tapes. Wash inside the
appliance with lukewarm water and bicarbonate
of soda ( 5 ml to 0.5 litre of water). Do not use
soap or detergent as the smell may linger. Dry
thoroughly.
D200

For maximum efficiency

Make sure that the appliance is cleaned
properly.
Make sure that the door is closed properly.
Do not position the appliance near to sources of
heat.
Do not over-fill your appliance, air MUST be
allowed to circulate.
Fig. 1