Technical Data; Installation - AEG Electrolux S74000CSM0 User Manual

42

Technical data

Problem
The appliance does not
operate.
The lamp does not work.
"dEMo" appears on the
display.
As much as the advice does not lead to result, call the nearest brand-mark service.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Downloaded from Fridge-Manual.com Manuals
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The appliance is in demonstra-
tion mode.
Height
Width
Depth
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
Close and open the door.
Keep pressed approximately 10
sec the OK button since a long
sound of buzzer is heard and the
display shut off for a short while:
appliance start works regularly.
S73600CSM0
1850 mm
595 mm
658 mm
18 h
230 - 240 V
50 Hz
Solution
S74000CSM0
2010 mm
595 mm
658 mm
18 h
230 - 240 V
50 Hz