Starting A Programme; Programme Progress; Interrupting A Programme/Adding Washing; End Of The Wash Cycle/Removing The Washing - Electrolux Swissline GL EWF 1182 User Information

Starting a programme

1.Check that the tap is turned on.
2.Press the START/PAUSE button. The programme is started or starts after
the time delay set has elapsed.
If after the START/PAUSE button has been pressed E40 flashes in the multi-
display, the END indicator flashes 4 times and at the same time an acoustic
signal sounds 4 times, the door is not closed properly. Push the door firmly
closed and press the START/PAUSE button again.

Programme progress

• The programme progress display shows the programme step that is cur-
rently being performed.
• The multi-display indicates the estimated time remaining (in minutes) until
the end of the programme.
During the washing cycle the remaining time may be increased or stay the
same for a while as the programme adjusts itself to different conditions (e.
g. type and quantity of laundry, out of balance spin detection, special rinses,
etc.).

Interrupting a programme/adding washing

Interrupting a programme
• A washing programme can be interrupted at any time by pressing the
START/PAUSE button. It is then re-started by pressing the START/PAUSE
button again.
• To stop the washing machine before the programme has ended, turn the
programme knob to OFF. Important! Be careful if there is water in the ap-
pliance!
Adding washing
It is possible to add washing, as long as the DOOR light is lit green.
1.Press the START/PAUSE button. The door can be opened.
2.Shut the door and press the START/PAUSE button again. The programme
continues.

End of the wash cycle/removing the washing

At the end of the programme, END lights up on the programme progress
display. The door can be opened as soon as the DOOR indicator is lit green.
1.Open the loading door and remove the washing.
2.Turn the programme knob to OFF.
16