Z Starting The Programme; Z Programme Time/Programme Status; Z Changing The Programme Before; Z Cancelling The Programme - Electrolux SWISSLINE WA SL5M 102 Instructions For Use Manual

Starting the programme
X Lightly press the Start button.
 The pilot lamp illuminates and the programme runs
through automatically.
With child lock activated:
X Hold down the Start button and actuate the Quick
Wash button.
Programme time / programme status
The individual programme steps and remaining time are
displayed during the washing programme.
Changing the programme before starting
X Lightly press the desired programme button once
again.
 Select additional programmes.
X Select any additional functions that may be needed.
Cancelling the programme
Cancel the programme by repeatedly pressing the Quick
Wash button until «Open door» is displayed.
With child lock activated:
X Hold down the start button while selecting a new
programme.
When restarting the programme:
X Repeat the detergent addition.
Ending the programme with rinsing stop
You have selected the additional rinsing stop function.
The laundry will be held in the last rinse water.
The display will show «Rinsing stop».
You have two options for ending the programme:
The laundry can be spun
X If the spin speed was not changed when the
programme was selected, this can be done using the
selection button for the spin speed
X Press the Start button.
 The water will be pumped out and the laundry spun.
X By pressing the
to be kind to your laundry (e.g. curtains).
The laundry can be removed dripping wet
X Press the Quick Wash button twice.
 The rinse water is pumped out.
With child lock activated:
X Hold the Start button down at the same time.
.
button, the spin can be ended early
39
Programme end
The programme end is shown by the time 00:00h and
the words «Open door».
Tumbling the washing
The tumbling phase at the end of the programme lasts
5 minutes (excluding especially gentle wash programmes
such as wool, e.g.) and prevents creasing the laundry.
Removing the laundry
 During the loosening up phase:
(Drum is still turning / Time indicator 00:00h)
X Press the quick wash button once.
(Halt programme)
X Press the door open button and
X remove the laundry.
 At the end of the loosening-up phase:
X Press the door opening button and
X remove the laundry.
Remove any foreign objects (e.g. paperclips) from the
drum and rubber seal!
Otherwise there is a risk of rust!
Leave the loading door ajar to allow the machine dry
out.
Switching off the machine
X Close the water taps
X Switch off the main switch (on the building side)
In case of fitted models, the power supply must not be
interrupted to ensure the function of overflow protection.