Making The Appliance Level; Electrical Connection; Connecting To The Water Supply; Water Inlet - Electrolux Swissline GL EWF 1182 User Information

Making the appliance level

The four feet of the appliance are pre-ad-
justed.
Large degrees of unevenness can be
compensated for by individually adjust-
ing the height adjustable screw feet.
Use the special spanner supplied to do
this.
Important! Do not use pieces of wood,
cardboard or such like to level out une-
venness in the floor, but adjust the height
adjustable screw feet instead.

Electrical connection

Details about the voltage, type of supply and the fuses required are to be
found on the rating plate. The rating plate is next to the doorway.

Connecting to the water supply

Permitted water pressure
The water pressure must be at least 1bar (=10N/cm
a maximum of 10bar (=100N/cm
– If more than 10bar: Connect a pressure reduction valve.
– If less than 1bar: Disconnect the appliance end of the inlet hose from the
solenoid inlet valve and remove the flow meter. (In addition remove the fil-
ter using pointed pliers and take out the rubber gasket behind it.) Re-in-
sert the filter.

Water inlet

Attention!
• An inlet hose is supplied and can be found inside the machine drum.
• Do not use the hose from your previous machine to connect to the
water supply.
• This appliance must be connected to a cold water supply.
1.Open the porthole and extract the inlet hose.
30
2
=1MPa).
2
=0.1MPa) and may be