If Something Does Not Work - Electrolux ENB 3450 Instruction Book

GB

If something does not work

During operation of the appliance some smaller but
annoying trouble can often occur, which does not
require calling a technician out. In the following chart
information is given about them to avoid unnecessary
charges on service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating
sound). This is not trouble, this goes together with the
operation of the appliance.
Problem
It is too warm in the
refrigerator.
It is too warm in the freezer.
Water flows at the back plate
in the refrigerator.
Water flows into the chamber.
Water flows onto the floor.
There are too much frost and
ice.
The compressor operates
continually.
The appliance does not work
at all. Neither cooling, nor
lighting works.
The appliance is noisy.
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
74
Possible cause
Thermostatic control can be set wrongly.
If products are not cold enough or placed
wrongly.
The door does not close tightly or it is not shut
properly.
Thermostatic control can be set wrongly.
The door does not close tightly or it is not shut
properly.
Products in big quantity to be frozen were put in.
Products to be frozen are placed too closely to
each other.
It is normal. During automatic defrosting frost
melts on the back plate.
The outlet of the chamber can be clogged up.
Products placed in can prevent water from
flowing into the collector.
The melting water outlet flows not into the
evaporative tray above the compressor.
Products are not wrapped properly.
Doors are not shut properly or do not close
tightly.
The thermostatic control can be set wrongly.
The thermostatic control is set wrongly.
Doors are not shut properly or do not close
tightly.
Products in big quantity to be frozen were put in.
Too warm food was put in.
Plug is not connected to the mains socket
properly.
The fuse burnt out.
The thermostatic control is not on.
Electrical network broke down.
The appliance is not supported properly.
We draw it to your attention again that the
appliance operates discontinuously, so the
stopping of compressor does not mean being no-
current. That is why you must not touch the
electrical parts of the appliance before breaking the
circuit.
Set the thermostat knob to higher position.
Place the products according to the chapter
„Storing in the refrigerator".
Check if the door closes well and the gasket
is unhurt and clean.
Set the thermostat knob to higher position.
Check if the door closes well and the gasket
is unhurt and clean.
Wait some hours and then check the
temperature again.
Place the products in a way so that cold air
could circulate among them.
Clean the outlet.
Replace the products so that they can not
touch the back plate directly.
Put the melting water outlet to the evaporative
tray.
Wrap the products better.
Check if the doors close well and the gaskets
are unhurt and clean.
Set the thermostat knob to a position that
gives higher temperature.
Set the thermostat knob to a position that
gives higher temperature.
Check if the doors close well and the gaskets
are unhurt and clean.
Wait some hours and then check the
temperature again.
Put food at max. room temperature.
Check the connection.
Change the fuse.
Start the appliance according to instructions
in chapter 'Putting it into use'.
Get an electrician to check it.
Check if the appliance stands stable (all the
four feet should be on the floor).
Solution