Electrolux ENB 3450 Instruction Book page 16

Refrigerator- freezer combination
Table of Contents

Advertisement

Disconnect the appliance from the electricity
supply.
Open the doors and dismount the double door
hinge (a,b) by removing the screws (2 pieces) (c).
(fig. 2)
Take off the double door hinge (a,b,c) by gradually
removing it from the cabinet, slightly tilting both
doors. Do not forget to remove the plastic spacer (b)
under the hinge. (fig. 2)
Take off the refrigerator door by pulling it slightly
downwards.
Take off the freezer door by pulling it slightly
upwards.
Unscrew the top door hinge pin (d) of the refrigerator
then screw it back on the other side. (fig. 1)
Remove the insert of the plinth (e) by a screwdriver.
(fig. 4)
Unmount the lower hinge pin (f) and its washer (h)
and mount them on the other side.(fig. 4)
Replace the insert of the plinth (e) on the other side.
Remove the covering nails (3 pieces) (n,k) of the
double door holder on the left side and put them to
the other side. (fig. 2)
Remove the (t, z) plugs from both doors. (fig. 3)
Remove the (u, v) door closing devices by
unscrewing the (s) screw.
Replace the (u, v) door devices on the opposite side
of the other door after turning them, then fix them by
screwing the (s) screw.
Replace the (t, z) plugs on the opposite side.
Fit the pin of the double door hinge (m) into the left
drill of the freezer door. (fig. 2)
Fit the freezer door to the lower door hinge pin (f).
(fig. 4)
Fit the refrigerator door to the upper door hinge pin
(d) then slightly tilting both doors fit the pin of the
double door hinge (m) into the left drill of the
refrigerator door.
Opening both doors fix the double door hinge onto
the left side using the screws (2 pieces) (c). Do not
forget to replace the plastic spacer (b) under the
hinge. Be careful that the door edges are parallel
with the edge of the mantle.
Put over the handles (r) on the other side and put the
plastic covering nails (p) supplied in the plastic bag of
this instruction book into the holes set free. (fig. 5)
Put the appliance to its place, set it level, and apply
to voltage it.
In case you do not want to perform the procedures
above, call the nearest brand-mark service. Technicians
will accomplish the refitting expertly for charge.
fig. 2.
fig. 3.
fig. 4.
fig. 5.
GB
77

Advertisement

Table of Contents
loading

Table of Contents